Product Characteristics
90-Degree Right Angle Power Transmission
Spiral bevel gears realize vertical power steering without complicated adapters, flexibly adjust power direction for synchronous transmission of screw jacks and conveyors.
Carburized Precision Ground Bevel Gear Pair
Gears are carburized, quenched and finely ground for even surface hardness, low vibration during meshing and stable efficiency at variable speeds with frequent forward-reverse rotation.
Multi-orientation Universal Mount Base
Standard mounting flanges and positioning shoulders on four sides of housing allow flexible swap of input and output shafts, supporting vertical, horizontal and inverted installation for limited equipment space.
Product advantages
High Transmission Efficiency & Low Energy Consumption
Large curved tooth contact area cuts power loss far below worm gear drives. Less heat is generated during long continuous operation to reduce motor energy cost for assembly lines.
Wide Allowable Torque Range
Sufficient torque margin supports both light fine adjustment and heavy jacking loads. No slipping or tooth breakage occurs whether used alone or in multi-unit synchronous linkage.
Easy Maintenance & Superior Sealing
Integrally cast housing with multi-layer oil seals prevents oil leakage and dust ingress. Separate oil sight glass and grease fitting enable oil inspection and replacement without full disassembly.
Product detail photos
Product Description
| Right Angle Bevel Gear Drive |
Partial drawing display
Our advantages
Eight reasons to choose us
We have our own factory
Multiple certificate certifications
Customizationand selection Steps
Payment and Price Terms
Production and testing
Packaging and transportation
Signing for receipt and after-sales service
FAQ
Q: Do input and output shafts deliver identical torque on right angle bevel gearbox?
A:Models with 1:1 ratio provide nearly equal rated torque with minor mechanical loss. Reduced ratio versions multiply output torque based on gear ratio.
Q:What extra protective accessories are required for dusty outdoor construction sites?
A:Shaft dust covers, anti-corrosion housing paint and waterproof sealing rings are optional to block sediment and rainwater from entering gear cavity.
Q: Is coaxial alignment necessary for two parallel right angle bevel gear drives?
A:Strict coaxial calibration is mandatory. Axis offset creates extra radial impact force, leading to rapid seal failure and uneven unilateral gear abrasion.
Hot Tags: right angle bevel gear drive, China right angle bevel gear drive manufacturers, suppliers, factory
